To load a map into a device you first need to open one as described in the previous Load Map from PC section. Now you need to click on one of the 3 connect buttons

Tuning Menus and Connect.

Connect Button on Top Toolbar

Connect button on left bottom information bar.

The selection block below will appear.

If you do not want to save the map and want to go live on the device again then press the Upload to PC button.

If you want to save the map in the devise, click on Download to Device.

This button will not save critical setup values. If the Save Setup data of the device was not set to On while it was live, then no setup values will be saved.

This is handy if your setup is right but you want to load matrix and graph data only. Note that it does catch you out sometime if it is not set.

If you want to Clone the Device, then press the Clone button called Dolly.

This will also load the critical values with setup and graph data end make the device exactly the same as the map of the device it was saved from. NB! It is important to disconnect the output harnesses from the device and go through the setup before attempting to power it in the application. The warning below will appear to remind you.

If you want to Close and Exit without saving press this button.