Viewing 2 posts - 1 through 2 (of 2 total)
You must be logged in to reply to this topic.
Hello again and thanks for the help in the past with some installation issues.
Insall is complete, startup map loaded and tweeked to my setup.
Whats happening is that when i turn the ign on the fuel pump primes up fine, then i crank, no more power to fuel pump or ign coil as they are on the same driver
I am getting 5 to 6 volts to the other driver, O2 and injectors
The only thing ive done differently is wired the original map sensor in.
Any Ideas
Regards Mick
I have put the spitronics map sensor back on and cranked engine over with logger and it appears to have a vac signal.
what other parameter might not allow power to fuel pump and ign coil ??
Regards Mick
You must be logged in to reply to this topic.