8 Cylinder

Below are links for the Mercury2 connections on all the different variations of standard coils without drivers and intelligent coils with built-in drivers. Note on each drawing the software settings are displayed. Make sure to follow the start-up procedure to ensure all the settings are correct before attempting to start the engine. Always disconnect P2 and P3 before switching the ECU on.

Standard Coils – No Drivers

1 Coil with Distributor 2-Way Coil Driver

1 Coil with Distributor Single Coil Driver

4 Coils Wasted Spark

8 Coils COP Wasted Spark

8 Coils COP Full Sequential

Intelligent Coils – Built-in Driver

1 Coil with Distributor

4 Coils Wasted Spark

8 Coils COP Wasted Spark

8 Coils COP Full Sequential

Add-on Harness – Built-in Driver

8 Coils COP Wasted Spark Add_on – IV8X01-2

8 Coils COP Full Sequential Add_on – IV8X01-2

Was this article helpful?

Related Articles

Leave A Comment?

You must be logged in to post a comment.