This block lets the tuner select the different sensors that he requires for his application. Not all the sensors are used but each one has different features that makes the engine perform at its best. If a sensor is not used, leave the block unchecked. This will free up valuable processor time. Also make sure the wiring to that sensor is properly isolated as there is power on the leads that could short circuit and damage the ECU as a result. Some of the sensors cannot be altered or will be forced on by the firmware.
Calibration
Some of the inputs can be calibrated by clicking on this calibrate button next to it. This allows for a wider range of sensors to be used and calibrated in the software.
Leave A Comment?
You must be logged in to post a comment.