This firmware will take a normal RPM pulse and convert it into different triggers like 60-2, 36-1, 24 plus TDC etc. for OEM managements. This will keep them active so that they can run other functions still required like Dash board tacho’s etc. Note that the classes that are not used by the converter is not displayed to simplify the chart. If firmware is developed they will be added.
| Mercury2 Hardware | Bas | |
| Hardware Inputs | ||
| External Map Sensor | ||
| Built In Map Sensor (optional) | ||
| TPS Sensor | ||
| Water 2K NTC or Tap-In | ||
| Air 10K NTC or Tap-In | ||
| Lambda Narrow or Wide Band | ||
| Battery Volts | 1 | |
| Power Management | 1 | |
| Crank Trigger Pulse | 1 | |
| TDC/Home Pulse | ||
| UART Comms Port | 1 | |
| Hardware Outputs | ||
| Low Volt Negative Drivers | 2 | |
| Low Volt Positive Drivers | ||
| General Purpose Input / Output | ||
| Features | ||
| Graph Tuning MAP | 1 | |
| Matrix Tuning MAP or TPS | 1 | |
| Altitude Compensation | ||
| Idle Control | ||
| Dual Maps | ||
| Dual Injectors | ||
| Split Sequential Injection | ||
| Full Sequential Injection | ||
| Fuel Pressure Control | ||
| V-Tech /Vanos Cam Control | ||
| Launch control | ||
| Anti-Lag control | ||
| Flat-Shift control | ||
| RPM Calibration | ||
| Epoxy filed | 1 |
Leave A Comment?
You must be logged in to post a comment.