Converter Selection

This firmware will take a normal RPM pulse and convert it into different triggers like 60-2, 36-1, 24 plus TDC etc. for OEM managements. This will keep them active so that they can run other functions still required like Dash board tacho’s etc. Note that the classes that are not used by the converter is not displayed to simplify the chart. If firmware is developed they will be added.

Orion Hardware MIC  
     
Hardware Inputs    
External Map Sensor    
Built In Map Sensor (optional)    
TPS Sensor    
Water 2K NTC or Tap-In    
Air 10K NTC or Tap-In    
Lambda Narrow or Wide Band    
Battery Volts 1  
     
Crank Trigger Pulse 1  
TDC/Home Pulse    
     
UART Comms Port 1  
USB/Programmer 3Pin PCB Con 1  
Bootloader 1  
     
Hardware Outputs    
Low Volt Negative Drivers 2  
Low Volt Positive Drivers    
High Volt Negative Coil Drivers    
     
General Purpose Input / Output    
     
Features    
Graph Tuning MAP 1  
Matrix Tuning MAP or TPS 1  
Altitude Compensation    
Idle Control    
Dual Maps    
Dual Injectors    
Split Sequential Injection    
Full Sequential Injection    
Fuel Pressure Control    
V-Tech /Vanos Cam Control    
Launch control    
Anti-Lag control    
Flat-Shift control    
RPM Calibration    
     
Can be Epoxy filed 1  

Was this article helpful?

Related Articles

Leave A Comment?

You must be logged in to post a comment.