The following guidelines in this manual will ensure proper product operation the first time. Failure to install the product correctly may damage it or other equipment permanently. These failures will solely be the responsibility of the installer and no guarantees will be given by us. Make sure you have read the Terms and Conditions in this manual or on the website www.spitronics.co.za before you install this product. By installing the product you automatically agree to these conditions. All equipment is tested before it leaves the factory. We accept no liability for malfunctioning of the equipment, or to injury that may result from installation or the use of the equipment. We also accept no liability for costs of traveling of transportation of the equipment or parts or vehicle recovery due to failures of any equipment. Please read the instructions and drawing and make sure you understand before you begin.

2.1 Operator Safety

• Use only proper tools and products suited for auto installations. Substandard products and installation procedures may cause failure to the equipment having your customer break down in dangerous areas.
• Use correct thickness of wire to carry the entire current requirement for that circuit. Too thin wires will heat up and may start a fire causing injury.
• Use fuses to protect each circuit separately. Joint circuits require large fuses which may heat and melt lesser circuits causing fires.
• Solder joints, and cover it with shrink sleeve to prevent loose connections which may cause fires. Space solder-joints so that they do not sit next to each other in the harness thus minimizing the chance of a short circuit.

See the individual Safety Precautions for each product.