This feature is used for Speedometer Calibration. This is handy for engine conversions.
You can adjust the number of output pulses per prop shaft revolution. You can also do a fine calibration on the speedo. Always start with a calibration value of 100. Then adjust the Pulses till you are as close to the value as possible. Then go to calibration and make a Percentage adjustment to get it to read accurate. Speedos usually read a bit over to compensate for Tyre wear and keep the driver in the limits.
Note that the Speedometer Calibration block is only available in Ver 3.3C onwards.
Leave A Comment?
You must be logged in to post a comment.