If you open the software without a live device connected, you will come to the main pallet or screen which forms the framework of the Hyperspace software. It looks the same for all the devices. From here you can open map files, connect to devices and set basic settings required for the software to operate. See below all the functions that can be set from here.
At the top bar is the start instructions to manipulate the software.
See the Sub folders for more detailed information.
At the bottom left corner is a connect button and also a tab that show the status and ECU that are connected.
At bottom right corner is connection information. This will indicate which Comms Port is being polled for a device. If you have changed the USB cable to another one, then this Comms Port may not be the Port number that the software remembered. Click on the Connect button then the software will look on all the available Ports for a device. Once a device is found, this will be saved in the Config file to cut down on start time for the next connection.
See the sub folders for detail explanations.
Leave A Comment?
You must be logged in to post a comment.