Below are links for the Mercury2 connections on all the different variations of standard coils without drivers and intelligent coils with built-in drivers. Note on each drawing the software settings are displayed. Make sure to follow the start-up procedure to ensure all the settings are correct before attempting to start the engine. Always disconnect P2 and P3 before switching the ECU on.
Standard Coils – No Drivers
1 Coil with Distributor 2-Way Coil Driver
1 Coil with Distributor Single Coil Driver
6 Coils COP Full Sequential
Intelligent Coils – Built-in Driver
3 Coils Wasted Spark
6 Coils COP Wasted Spark
6 Coils COP Full Sequential
Add-on Harness – Built-in Driver
Straight 6 Coils COP Wasted Spark Add_on – CS6X01-2
Straight 6 Coils COP Full Sequential Add_on – CS6X01-2
V6 Coils COP Wasted Spark Add_on – CV6X01-2
V6 Coils COP Full Sequential Add_on – CV6X01-2
Leave A Comment?
You must be logged in to post a comment.