To program your Product, first connect the Programmer to the Product’s Com Port. Connect only the P1 12-Way connector and earth the Product. Switch the ignition on. Click on the 
button to connect.
The download 
button will become active, click on it.
Now use the Browse button to select the correct HEX file on the hard disk or CD. Do not at any stage press the Erase all code space button.
Select the Files of Type to be Intel Hex (*.hex) then go to Look in: to search for the correct file.
Click Open when it is selected.
Click Download to program the Product.
Click the disconnect 
button when it is finished and switch the ignition off. Disconnect the programmer and connect the USB/UART Converter cable. Do not connect the output cables before you run through the startup procedure. This will ensure that load the right firmware and not to damage the product.
Leave A Comment?
You must be logged in to post a comment.