Power Supply

12V Ignition power 200mA, filtered by reverse polarity Diode, 700mA Poly switch and 25V Tranzorb
2.5mm2 Earth Strap
12V Driver Power up to 14 amps depending on power used by items driven.

Fixed Inputs

2x Digital Inputs for Magnetic, Hall or Optic sensors. (Jumper selectable)
3x Analog Input 0-5V (May be used by firmware as digital)
1x Built in 3 Bar MAP Sensor input 0-5V (Optional. Sensor is sold Separately)
1x Water Temperature Input 2K NTC Resistance Sensor with 1K pull-up resistor Jumper selectable
1x Air Temperature Input 10K NTC Resistance Sensor with 7K5 pull-up resistor Jumper selectable
3Pin USB D-Bug Connection

Fixed Outputs

4x 18A 500V Ground / Floating output *
4x 6A 36V +12V / Floating Overcurrent Protected *
5x 19A 41V Ground / Floating
1x 19A 41V Ground / Floating, 1K pull-up resistor to 12V Jumper selectable
5V 600mA Power Output for TPS & Map Sensor and Magnetic Pickups

* These outputs share the same output from the Micro

General Purpose I/O

These GP I/O can be used as one of the following features. Note that they are software selectable and requires Jumper settings on the board.

I/O 1

18A 500V Ground / Floating output
Digital Input to Ground
Analog 0 to 5V with 10K Pull-up to 5V
Serial Bus1

I/O 2

18A 500V Ground / Floating output
Digital Input to Ground
Analog 0 to 5V with 74K Pull-up to 5V
Serial Bus2

Communication

Software UART Connection via USB2 converter cable
Universal Serial Bus (Optional)
Bootloader installed for firmware programming via the USB cable

Dimensions

Size 144 x 68mm x 22mm
Weight 187g Non Resin filed *
5 x Connector Type Plastic Molex 12, 10, 8, 6, 4

* This unit can be resin filled. Weight will increase depending on the type of resin.