Below are links for Mercury2 on all the different variations of injector driver connections. Note that on each drawing the software settings are displayed. Make sure to follow the start-up procedure to ensure all the settings are correct before attempting to start the engine.
There are 2 groups of drawings.
- Connection to the MEX01-2 harness directly. With this connection you have to make your own harness on the engine for injectors to group them with power wires.
- Connection of the IV8X01-2 optional Add-on Injector harness. The add-on harness makes wiring easier but it must be bought for a specific engine like straight six or V8 etc. Note that these part numbers differ for each engine combination.
MEX01-2
High Impedance
4 Injector Split – Sequential TBI
16 Dual Injector Split – Sequential
16 Dual Injector Full – Sequential
Low Impedance
4 Injector Full – Sequential TBI
8 Injector Full – Sequential
16 Dual Injector Split – Sequential
16 Dual Injector Full – Sequential
IV8X01-2
Leave A Comment?
You must be logged in to post a comment.